Crib Sheet Tutorial

So this tutorial is from dana-made-it.com. But for some reason, when I click on my pin, Pinterest thinks it's a fishy website. And Since I've had 3 viruses on my computer in the last 2 years, I'm paranoid they're right. So I'm copying it here to my blog so I can view it without being scared. :)

You’ll need:
* 2 yards of fabric
* 80 inches (204 cm) of skinny 1/4 inch elastic

* Cut out a rectangle that’s: 45 x 67 inches (114.5 x 171 cm)
* Fold that into fourths (fold it in half and in half) and cut an 8 x 8 in (20.5 x 20.5 cm) square out of the corners, so that your fabric looks like this:
Another way to do this (if you’re making multiple sheets), is to cut out a pattern piece that’s 1/4 the size of your sheet. It looks like this (or the state of Utah):
Then before cutting anything out, you can fold your fabric into fourths, lay that on top, and easily cut it out.

Okay, with your fabric cut, let’s start sewing.

* Take the two sides of one corner and bring right sides together. Pin them and sew down the side. This is creating a “pocket” of sorts, to go around the corners of the mattress. Do this to all four corners of the sheet:
* Serge the seams, zigzag or leave the seams raw.

* Serge around the entire outside of the sheet. This makes is easy to create a casing for the elastic. If you don’t have a serger, just iron your fabric over 1/4 inch all the way around and then continue to the next step….

* Iron under the entire edge of the sheet. You are creating a casing, to string very skinny elastic through.
* Sew down the casing. You don’t need to pin around the entire sheet before you sew (that takes too long) but DO pin a start and stop point so that you leave an opening to get the elastic In and Out. Start sewing from the START point, all the way around the STOP point:
* Insert the elastic. Taking your 1/4 inch wide elastic, attach a safety pin to one end, and pin the other end to the sheet. Start stringing it through the casing, all the way around till it comes out the other side:
* Overlap the ends and sew them together a few times with a zigzag stitch:
* Then sew your casing closed.
And you’re done!

Again, this is not my tutorial. It's from dana-made-it.com. But pinterest thinks it's a fishy website so I'm not going there anymore. :)